Resin Jewelry Stones Mold
Set of 5
Compatible with most resins or other casting materials like epoxy resin, polyester resins, polymer clay, and resin pigment, resin dye, etc.
Made of silicone material that resists the growth of any cuts when under tension especially when twisting the mold to remove your coaster molds, and also has a high heat tolerance built to last for thousand uses.
Super shiny perfectly flat smooth texture scratch-free artwork pieces both on touch and by sight. Paint, resin, and other mixture will also peel and wipe off in seconds due to the silicone smooth surface! You can perform a quick test by running the tip of your index finger through the mold inner surface.
Soft and flexible while maintaining their high tear strength. It also has non-stick properties making the demolding process stress-free.
How to use
Pouring the resin mixture:
- Pour your resin mixture into the molds
- Run your torch over each coaster to remove the air bubbles.
- Let it cure for at least 8-10 hours (depending on how thick you poured).
- Then carefully, peel back the silicone away from your completely cured resin artwork. You may sand down any edges if necessary.
- and Ta-Da! You now have beautiful pendant ready!
Cleaning Tips:
1. You may clean the mold with water before using it to remove unwanted debris that can mix with your resin mixture.
2. When finished with your silicone molds, wash them with warm water and mild soap.
3. Use a soft cloth to wipe clean.
4. Make sure your molds are completely dry before storing them.
Storage tips:
1. Place on a flat level surface
2. Store in a cool, dry environment out of ultraviolet light.
3. Avoid the direct sunlight
These coasters would make a gorgeous gift!
